Difference between revisions of "bridge-utils"

From Noah.org
Jump to: navigation, search
m (Created page with 'Category:Engineering Category:Networking When creating a bridge interface, the new bridge interface becomes the primary interface that you talk to. It assumes control of…')
 
m
Line 20: Line 20:
 
ip route add 10.10.10.0/24 dev br0
 
ip route add 10.10.10.0/24 dev br0
 
ip route add default via 10.10.10.1
 
ip route add default via 10.10.10.1
 +
</pre>
 +
 +
== /etc/network/interfaces ==
 +
 +
<pre>
 +
auto br0
 +
iface br0 inet static
 +
    address 10.10.10.10
 +
    netmask 255.255.255.0
 +
    gateway 10.10.10.1
 +
    bridge_ports eth0
 +
    bridge_hello 1
 
</pre>
 
</pre>

Revision as of 17:21, 10 September 2012


When creating a bridge interface, the new bridge interface becomes the primary interface that you talk to. It assumes control of whatever your original physical interface was doing. This is dangerous if you are bridging your primary ethernet interface because if you don't setup the bridge correctly you will be locked out of your machine.

Local:

ssh -o Tunnel=ethernet -f -w 0:0 10.10.10.7 true

Remote:


ifconfig tap0 up
brctl addbr br0
brctl stp br0 on
ifconfig br0 up
brctl addif br0 tap0

ip route add 10.10.10.0/24 dev br0
ip route add default via 10.10.10.1

/etc/network/interfaces

auto br0
iface br0 inet static
    address 10.10.10.10
    netmask 255.255.255.0
    gateway 10.10.10.1
    bridge_ports eth0
    bridge_hello 1